Efficiently heat your pool with the Beluga® Gen2 Solar Pool Heater. Hook this new cap design up to a garden hose, and channel heat from the sun into your above ground or inground pool. Instead of using a solar cover or other heating devices, the Beluga® Gen2 Solar Heater is designed to work with any standard 1 ½" return fitting, and its redesigned fiberglass-reinforced cap enforces maximum durability.
Features:
- Heats your above ground or inground pool
- Channels heat from the sun
- Uses a simple garden hose
Benefits:
- Solar Energy: The Beluga® Gen2 Solar Pool Heater uses the heat from the sun to heat the water in your hose before it returns to your pool.
- New Design: The Gen2 design features a new, improved fiberglass reinforced cap that ensures maximum durability.
Instructions:
- Turn off the pool pump
- Remove the existing 1 ½" threaded eyeball fitting (if required)
- Screw the device into the pool inlet
- Attach a garden hose to the outlet at the top of the device
- Lay the hose in a sunny area
- Place the discharge end of the hose over the pool
- Turn on the pool pump
- Adjust the tab on the face of the device towards a closed position to force water into the garden hose. You may need to close the tab to fill the garden hose aggressively
- Once water is floating from the opposite end of the hose, adjust the flow to approximately a ½" diameter or smaller stream. Remember - the longer the water is in the hose, the warmer the water will be when it exits
